Standing seam and metal panel roofing, roof repair and full replacement in Meriden. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Meriden.
A coating buys real years on the right roof and wastes money on the wrong one. We will tell you honestly which kind you are looking at.
Guards and screens so you are not up a ladder every fall digging pine needles out of the gutter by hand.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
A skylight has to be woven into the roof, not caulked to it. That is the difference between a fix that lasts a season and one that holds.
A replacement is a big spend and it should feel orderly. We schedule around dry weather, work in the right order, and never leave a house open overnight.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
An older roof deserves to keep its character. We repair rather than replace wherever the material still allows it.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
Standing seam and metal panels have been our specialty since 2002. Around Meriden that means everything from a small porch roof to a full house in dark green, burgundy or bronze, cut and fit on site by crews who have done hundreds of them.
A metal roof done right in Meriden should be quiet inside, straight from the street, and still there long after you have stopped thinking about it. That takes sound decking, real underlayment, and panels that are actually square. We do not skip those parts to save a day.
Here is what Meriden homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
The questions that come up on just about every estimate we write.
Sometimes. If the decking is sound and there is only one layer of shingles, a Meriden metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Often, yes. Plenty of the Meriden roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
A typical Meriden shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Most Meriden metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Much less than people expect. Over solid decking with underlayment under it, a Meriden metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
We do. After a storm we photograph the damage on your Meriden roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
Real feedback from homeowners whose roofs we have worked on.
"Called about shingles that blew off in a storm. They were out the next morning, patched it, and would not take a dime more than what the estimate said."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Very pleased with the roof. The only thing I would mention is that the estimate took a couple of days to come back, but once it did everything went right on schedule."
Roofing Brothers also serves these towns near Meriden.